Submit Manuscript  

Article Details


Photocatalytic Degradation of 2-propanol Over TiO<sub>2</sub>-based Thin Films in a Simulated Pilot Microreactor

[ Vol. 2 , Issue. 2 ]

Author(s):

Corrado Garlisi, Ahmed Yusuf and Giovanni Palmisano*   Pages 97 - 104 ( 8 )

Abstract:


<p>Background: Microreactor devices have attracted increasing attention over the last years due to their high surface-to-volume ratio, which ensures a high heat and mass transfer, short molecular diffusion distance and greater spatial illumination homogeneity compared to the traditional reactors. </P><P> Objective: The aim of this study was to model the kinetics of photo-degradation of 2-propanol over TiO<sub>2</sub>-based thin films in a gas-phase batch-reactor and simulate their performance in a microreactor device. </P><P> Methods: The reaction was carried out in a gas-phase batch-reactor, assessing the reactivity of singlelayer nitrogen (N)-doped TiO<sub>2</sub> and a bilayer consisting of N-doped TiO<sub>2</sub> as a bottom layer and copper (Cu)-doped TiO<sub>2</sub> as a top layer. The kinetics of the photocatalytic process was modelled by Langmuir– Hinshelwood (LH) model. The constants obtained from the LH model were used to simulate the performance of the photocatalysts in a microreactor, operating in a continuous flow mode and investigating the effect of the volumetric flow rate (Q), initial concentration of pollutant (C<sub>o</sub>), number of microchannels (n) and microchannel length (l) on the photo-degradation of 2-propanol. </P><P> Results: N-Cu-TiO<sub>2</sub> exhibited a higher reactivity but a lower adsorption ability towards the target pollutant compared to N-TiO<sub>2</sub>. To maximize and leverage the advantages of a microreactor, optimal operating conditions for a continuous flow mode, at a steady-state, should be moderately low Q and C<sub>o</sub>, long l and n that minimizes flow maldistribution in parallel. </P><P> Conclusion: The findings in this work could serve as a basis to design and fabricate efficient microreactors for the removal of VOC in air purification applications.</p>

Keywords:

Photocatalysis, microreactor, VOCs, bilayer thin-film structure, TiO<sub>2</sub>, nitrogen and copper doping.

Affiliation:

Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi, Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi, Department of Chemical Engineering, Khalifa University of Science and Technology, P.O. Box 127788, Abu Dhabi

Graphical Abstract:



Read Full-Text article